EN
5 - CONTROLS
THIS MANUAL IS PROPERTY OF SCM INDUSTRIA S.P.A - ANY TOTAL OR PARTIAL REPRODUCTION IS STRICTLY FORBIDDEN Cap. 5 Pag. 9/14
5.5 MACHINE START-UP - SHUTDOWN
(ev_5-5_0.0)
DANGER-WARNING:
before switching on the machine, ensure that all the tools are well tightened, that the set spindle
rotation speed is correct (see Chapter 9A) and that the router protection suitable for the type of
machining has been installed.
NOTE-INFORMATION:
carry out the checks of par. 5.4.
DANGER-WARNING:
with single-phase motor avoid short switching cycles.
DO NOT restart the machine immediately after a stop command.
Wait for at least 30 s. before starting the start procedure.
NOTE-INFORMATION:
under RESTING conditions it's advisable to leave the machine with the surfacing tables (F) always
open.
To Next Page
Loading...
