SCM CU 300C - Adjustments

8 - USE AND ADJUSTMENT OF MORTISER
EN
Pag. 8/11 - Cap. 8 THIS MANUAL IS PROPERTY OF SCM INDUSTRIA S.P.A - ANY TOTAL OR PARTIAL REPRODUCTION IS STRICTLY FORBIDDEN
8.3 ADJUSTMENTS
(fs_8-3_0.0)
With the use of slotter it is possible to carry out holes and slots both dead or through.
- Place the workpiece on the table, stopping it and securing it by means of the presser (B fig. 8.3).
Fig. 8.3