5 - CONTROLS
EN
Pag. 14/14 - Cap. 5 THIS MANUAL IS PROPERTY OF SCM INDUSTRIA S.P.A - ANY TOTAL OR PARTIAL REPRODUCTION IS STRICTLY FORBIDDEN
5.11 AUTO-BRAKE MOTOR
(ev_5-11_0.0)
ONLY FOR U.S.A. and CANADA VERSION
ONLY FOR MOULDER UNIT
The spindle rotation occurs by means of autobrake motor.
When you switch off the motor or you shut off the power, the motor automatically brakes and remains braked until
the next spindle start.
In case of adjustment as cutter fitting etc. for which the spindle shall turn freely, turn selector (3 fig. 5.11) to
.
NOTE-INFORMATION:
the material used for auto-brake motors does not contain any cancerous components.
Fig. 5.11
To Next Page
Loading...
