9 - THICKNESSING USE AND ADJUSTING
EN
Pag. 6/12 - Cap. 9 THIS MANUAL IS PROPERTY OF SCM INDUSTRIA S.P.A - ANY TOTAL OR PARTIAL REPRODUCTION IS STRICTLY FORBIDDEN
9.4 AUTOMATIC FEED AND SPEED CHANGE
(fs_9-4_0.0)
To switch on the feed turn lever (L fig. 9.5). Carry out this operation with the machine running.
NOTE-INFORMATION:
the feed is possible only if the cutterblock is rotating.
DANGER-WARNING
never machine workpiece of length and thickness lower than the values permitted (L = 120 mm;
thickness 3,0 mm), as in that case the system, which control the feed and the pressure on the
workpiece, can not operate and causes dangerous conditions.
Fig. 9.4
To Next Page
Loading...
