EN
9 - THICKNESSING USE AND ADJUSTING
THIS MANUAL IS PROPERTY OF SCM INDUSTRIA S.P.A - ANY TOTAL OR PARTIAL REPRODUCTION IS STRICTLY FORBIDDEN Cap. 9 Pag. 9/12
9.8 PRESSURE ROLLERS ADJUSTING
(fs_9-8_0.0)
The spring pressure of the feed rollers is adjusted at factory during the machine test to ensure the right piece feed.
Only in peculiar cases set bushes (E fig.9.8) by means of Allen wrench.
Uniformly adjust the spring pressure of the same roller on both sides.
NOTE-INFORMATION:
pressure should be increased to machine hard wood and/or large sized workpieces.
Fig. 9.8
To Next Page
Loading...
