EN
9a - OPERATIONS AND ADJUSTMENTS OF SPINDLE
THIS MANUAL IS PROPERTY OF SCM INDUSTRIA S.P.A - ANY TOTAL OR PARTIAL REPRODUCTION IS STRICTLY FORBIDDEN Cap. 9a Pag. 25/45
9A.33.4 HOOD-FENCE ADJUSTING FOR PROFILING WITH
ROTATION DIRECTION REVERSAL
(cu_9a-33-4_0.0)
DANGER-WARNING:
the machine is equipped with spindle rotation reversal (spindle rotation clockwise).
NOTE-INFORMATION:
the pilot lamp on the control board lights up when the tool rotates clockwise (that is in feed
direction).
DANGER-WARNING:
this rotation direction (fig. 9.33-4) is to be avoided as much as possible; as the cutter rotates in
"feed direction".
Make sure that the workpiece feed occurs in the direction opposite to the cutter rotation direction..
DANGER-WARNING:
NEVER make the workpiece feed in the tool rotation direction because there is the risk that the
workpiece is withdrawn by the pressure shoe.
DANGER-WARNING:
all adjusting operations are to be carried out with standstill spindle.
Adjust pressure shoes (see paragraph 9.50).
Fig. 9.33-4
To Next Page
Loading...