SCM CU 300C - Knife Adjustment; Knife Replacing; A Helicoidal Planer - Tips Replacement; Replacing the Throw-Away Knives

9 - THICKNESSING USE AND ADJUSTING
EN
Pag. 12/12 - Cap. 9 THIS MANUAL IS PROPERTY OF SCM INDUSTRIA S.P.A - ANY TOTAL OR PARTIAL REPRODUCTION IS STRICTLY FORBIDDEN
9.10 KNIFE ADJUSTMENT
(fs_9-10_0.0)
DANGER-WARNING
to handle the knives and the cutterblock you shall wear safety gloves.
For adjusting the knife projection see Chapter 7a.
9.11 KNIFE REPLACING
(fs_9-11_0.0)
DANGER-WARNING
to handle the knives and the cutterblock you shall wear safety gloves.
For adjusting the knife projection see Chapter 7a.
9.12A HELICOIDAL PLANER - TIPS REPLACEMENT
(fs_9-12a_0.0)
DANGER-WARNING
to handle the knives and the cutterblock you shall wear safety gloves.
See Chapter 7a.
9.12 REPLACING THE THROW-AWAY KNIVES
(fs_9-12_0.0)
DANGER-WARNING
to handle the knives and the cutterblock you shall wear safety gloves.
DANGER-WARNING
do not start planer spindle motor when knives are not fitted.
For adjusting the knife projection see Chapter 7a.