SCM CU 300C - Scheduled Maintenance

20 - MAINTENANCE
EN
Pag. 8/44 - Cap. 20 THIS MANUAL IS PROPERTY OF SCM INDUSTRIA S.P.A - ANY TOTAL OR PARTIAL REPRODUCTION IS STRICTLY FORBIDDEN
20.2 SCHEDULED MAINTENANCE
(ev_20-2_0.0)
Scheduled maintenance is of the utmost importance to obtain the best performance as well as a safe operation of
the machine.
DESCRIPTION INSPECTION / FREQUENCY ACTION
Safety circuit 20 years Contact the manufacturer
DESCRIPTION INSPECTION FREQUENCY ACTION
Brake release selector
operation check
Operation check Daily - See section 5.4
SAW - MOULDER
DESCRIPTION INSPECTION INTERVALS OPERATIONS
General machine
cleaning
Visual inspection Daily
- Clean with a vacuum cleaner
(Par.20-1).
Slideways (S fig. 20.1B)
of the sliding table
Visual inspection Weekly
- With aspirator remove chips
and dust (Par. 20.1).
- With a cloth or a brush drunken
with proper and not dangerous
product.
- Do not oil, do not grease.
Guides (A fig. 20.1B) of
squaring frame
Visual inspection Daily
- With aspirator remove chips
and dust (Par. 20.1).
- With a cloth or a brush drunken
with proper and not dangerous
product.
Slideways (B fig. 20.1B)
of the rail
Visual inspection Weekly
- With aspirator remove chips
and dust (Par. 20.1).
- With a cloth or a brush drunken
with proper and not dangerous
product.
- Do not oil, do not grease.
Cleaning the suction
hoods (T fig. 20.1B)
Visual inspection Weekly
- Disconnect the hoses from the
suction hoods, make sure that
there are no occlusions and
clean by means of an aspirator.
Rod (L fig. 20.1B) of the
fence
Visual inspection Daily
- With aspirator remove chips
and dust (Par. 20.1).
- With a cloth or a brush drunken
with proper and not dangerous
product.
Elements (C fig. 20.3)
of scorer unit
Visual inspection Weekly
- With aspirator remove chips
and dust (Par. 20.1); then
lubricate with grease (Par. 20.3).
Worms (A fig. 20.3) for
height adjusting and
tilting
Visual inspection Weekly
- Lubricate with grease (Par.
20.3).
Sliding cylinder (F fig.
20.1B) of the spindle.
Visual inspection Daily
- With aspirator remove chips
and dust (Par. 20.1).