SCM CU 300C - Optional accessories

3 - TECHNICAL SPECIFICATIONS
EN
Pag. 12/22 - Cap. 3 THIS MANUAL IS PROPERTY OF SCM INDUSTRIA S.P.A - ANY TOTAL OR PARTIAL REPRODUCTION IS STRICTLY FORBIDDEN
3.4 OPTIONAL ACCESSORIES
(ev_3-4_0.0)
Wagon attachment
Device for oblique cuts
Displacing wheels
SAW
Scorer assembly
Fence for parallel cuts with micrometric adjustment
Preparation for DADO SET (Version U.S.A.-CANADA)
Tablet support device
MOULDER
Tenoning table and hood Ø 275 mm (max. tool diameter 275 mm)
Anodised aluminium tables for moulder guide
Interchangeable moulder spindle
Moulding spindles available:
Ø 30 - Ø 32 - Ø 35 - Ø 40 - Ø 50 spindle to fit to the hole of the cutters used
Tenoning hood
Rotation direction reversal
SURFACE PLANING AND THICKNESSING MACHINE
Cutterblock with throw-away knives
Helicoidal planer with tips
Height adjusting of thicknessing table by handwheel
Mortiser with:
- Table size ................................................................................................................ 470X230 mm
- Longitudinal stroke ................................................................................................... 160 mm
- Trasverse stroke....................................................................................................... 120 mm
- Vertical stroke........................................................................................................... 110 mm
- Coupling of left-hand bit Ø max................................................................................ 16 mm
- Suction hood diameter ............................................................................................. 120 mm
- Suction air speed - chips dry (chips wet) ................................................................. 20 (28) m/sec
- Suction air consumption .......................................................................................... 814 (1140) m
3
/h
- Weight ...................................................................................................................... ~50 kg
- clamping arm
- selfcentering
chuck for bits of max. diameter ................................................... Ø max.16 mm