EN
7 - SUPPORTING FRAME AND FENCE FOR PARALLEL CUTS: USE AND
ADJUSTMENT
THIS MANUAL IS PROPERTY OF SCM INDUSTRIA S.P.A - ANY TOTAL OR PARTIAL REPRODUCTION IS STRICTLY FORBIDDEN Cap. 7 Pag. 19/26
7.24.4 FOURTH CUT
(ev_7-24-4_0.0)
- Move the sliding table to the end of stroke (see fig. 7.24-4), lock lever (L fig. 7.24-4).
- Turn panel 90° again. Rest side (C fig. 7.24-4) against aluminium rule and side (B fig. 7.24-4) to stop (T fig.
7.24-4) set to the cutting measure required; lock the panel with clamping device (G fig. 7.24-4) then carry out
cut (D fig. 7.24-4).
Fig. 7.24-4
NOTE-INFORMATION:
to cut smaller panels it is easier to work with the telescopic ruler positioned for bearing machining
(see fig. 7.24-4A).
DANGER-WARNING:
working against the fence, with the scorer on, should be carried out with the utmost care because
scorer
rotation is executed at the same time as workpiece feeding which causes it to be
carried along.
Fig. 7.24-4A
To Next Page
Loading...
