EN
1 - GENERAL INFORMATION
THIS MANUAL IS PROPERTY OF SCM INDUSTRIA S.P.A - ANY TOTAL OR PARTIAL REPRODUCTION IS STRICTLY FORBIDDEN Cap. 1 Pag. 17/24
1.9 TOOLS WHICH MAY BE USED
(ev_1-9_0.0)
-- SAW
The machine has been designed to use only tools for manual feed, proper for the material used.
By manual feed we mean the piece guidance by means of:
- the hand,
- the sliding table pushed by hand,
- the feeder.
-- MOULDER
Features of the tools required for manual feed:
- max. chip thickness 1.1 mm,
- tool shape round,
- chip exhaust space narrow.
As to the relation between tool and rotation speed see par. 9a.3.
Helicoidal planer with tips
Each tip-tool has 4 cutting edges so it can be utilized in maxim efficiency conditions without regrindings.
1.10 WORKING ENVIRONMENT
(gg_1-9_0.0)
The machine can work under these conditions:
Max. humidity 90%
Max. altitudine sea level: 1000 m (in case of higher altitude apply to the machine manufacturer)
Temperature: Min. +10° C ; Max. +35° C (macchina in operation)
Temperature: Min. +05° C ; Max. +35° C (machine off, not in working condition)
Always connect the machine to the suction system (see par. 4-5).
The machine may not be used in the open air.
The machine was designed for industrial use.
The machine may not operate in explosive rooms.
To Next Page
Loading...
