15 - PUSHER
EN
Pag. 2/2 - Cap. 15 THIS MANUAL IS PROPERTY OF SCM INDUSTRIA S.P.A - ANY TOTAL OR PARTIAL REPRODUCTION IS STRICTLY FORBIDDEN
15.1 PUSHER
(ev_15-1_0.0)
DANGER-WARNING:
when for the execution of a peculiar working, the operator is obliged to put his hands near the
tools, for safety reasons a proper pusher shall be used to move the workpiece forwards, to push it
against the fence or to remove it after the cutting.
Handle (A fig. 15.1) is supplied for this purpose and can be applied to pushers (D fig. 15.1) of different size by
means of screws (B and C fig. 15.1).
Fig. 15.1
By using a power dust aspirator clean:
- the pusher (H).
- The handle (A).
NOTE-INFORMATION:
in case of loss or breakage of the devices contact the manufacturer's SERVICE (Par. 1.3).
To Next Page
Loading...
