SCM CU 300C - Height Adjusting

EN
8 - USE AND ADJUSTMENT OF MORTISER
THIS MANUAL IS PROPERTY OF SCM INDUSTRIA S.P.A - ANY TOTAL OR PARTIAL REPRODUCTION IS STRICTLY FORBIDDEN Cap. 8 Pag. 11/11
8.3.3 HEIGHT ADJUSTING
(fs_8-3-3_0.0)
- Position the table at the correct height using the accessory handwheel (C fig. 8.3-3); lock it in position by
tightening the knob (G fig. 8.3-3).
Fig. 8.3-3