SCM CU 300C - Fitting the Scorer

4 - INSTALLATION
EN
Pag. 30/53 - Cap. 4 THIS MANUAL IS PROPERTY OF SCM INDUSTRIA S.P.A - ANY TOTAL OR PARTIAL REPRODUCTION IS STRICTLY FORBIDDEN
4.3.45 FITTING THE SCORER
(ev_4-3-45_0.0)
DANGER-WARNING:
use gloves for handling the scorer blade.
DANGER-WARNING:
before carrying out any of the operations make sure to cut the main electric power and disconnect
socket T from plug S.
U.S.A. and CANADA version:before carrying out maintenance operations, adjustments or to
dismount any machine member turn main switch (Y fig. 4.3-45) to 0, lock it then indicate this with a
sign.
DANGER-WARNING:
WAIT UNTIL THE SAW BLADES ARE STILL.
For fitting or replacing the scorer blade proceed in this way:
1) position the squaring frame (A fig.4.3-45) as shown in the figure and translate the wagon (H fig.4.3-45)
completely to the right.
2) Lower the lever (M fig.4.3-45) and open the guard (N fig.4.3-45).
3) Fit pin (B fig.4.3-45) in the blade-holding flange hole.
NOTE-INFORMATION:
(U.S.A. and CANADA version) a limit switch ensures that with guard (N fig. 4.3-45) open the motor
can not be started.
4) Loosen the lock nut (C fig. 4.3-45) using a 13 mm hex wrench and remove flange (D fig. 4.3-45).
5) In sequence mount the blade (E fig. 4.3-45) with the teeth opposed to the ones of the saw, the flange (D fig.
4.3-45) and the nut (C fig. 4.3-45).
6) Tighten the nut using the 13 mm wrench and the pin (B fig. 4.3-45).
DANGER-WARNING:
for safety reasons you must close guard (N fig. 4.3-45), otherwise:
- the machine does not start (U.S.A. and CANADA version).
- The guard interferes with the sliding table motion.
DANGER-WARNING:
in the U.S.A. and CANADA version, the scoring unit is set for use with double blade. If the simple
(single) blade is needed, position the supplied thickness (L fig. 4.3-45) between flange (F fig. 4.3-45)
and the blade.