20 - MAINTENANCE
EN
Pag. 24/44 - Cap. 20 THIS MANUAL IS PROPERTY OF SCM INDUSTRIA S.P.A - ANY TOTAL OR PARTIAL REPRODUCTION IS STRICTLY FORBIDDEN
20.18.2 SCORER SPINDLE
(ev_20-18-2_0.0)
DANGER-WARNING:
before carrying out any of the operations make sure to cut the main electric power and disconnect
socket T from plug S.
U.S.A. and CANADA version:before carrying out maintenance operations, adjustments or to
dismount any machine member turn main switch (Y fig. 20.18-2) to 0, lock it then indicate this with
a sign.
DANGER-WARNING:
WAIT UNTIL THE SAW BLADES ARE STILL.
DANGER-WARNING:
use proper gloves for handling the tools.
• Remove the saw blade as shown in Chap. 4.
• Disassemble the front guard (F fig. 20.18-2).
• Completely lower the saw assembly and incline it by 45° (see Chapter 6).
• Loosen the belt tensioner (E fig. 20.18-2) and take out the belt; fit the new belt in the same way and turn it
manually, making sure it is centred on the pulleys.
• Fit the saw blade as shown in Chap. 4.
• Fit the front guard (F fig. 20.18-2).
NOTE-INFORMATION:
the correct engraver belt tension is assured by the spring (G fig. 20.18-2) and it does not require
any adjustment.
To Next Page
Loading...
