EN
1 - GENERAL INFORMATION
THIS MANUAL IS PROPERTY OF SCM INDUSTRIA S.P.A - ANY TOTAL OR PARTIAL REPRODUCTION IS STRICTLY FORBIDDEN Cap. 1 Pag. 21/24
1.14.2 MACHINE SAFETY
(ev_1-14-2_0.0)
DANGER-WARNING:
always fasten the machine to the floor.
1- Be extremely careful when starting any working and periodically check the shields and safety devices.
Follow the instructions for grounding the machine's electrical system.
2- Never start the machine without having properly closed the covers in the area for blade and belt change.
3- Before starting the machine make sure that on the worktable or inside the guard there are no wood residues
or parts which do not relate to the working.
4- Do not machine workpieces too small or too big for the machine.
See relative paragraph 3.1 "DIMENSIONS OF WORKPIECE TO BE MILLED".
Ensure that the pushers are intact and efficient.
5- Do not machine pieces with defects (deflections, clefts, knots, metallic parts, ...).
6- The guards and reference rules or fence halves are to be fitted and set when the machine is off.
7- Work only with all guards properly fitted and efficient.
The use of the machine is not permitted if such conditions are not kept.
8- In case of long pieces use roller tables or table extensions (not supplied by SCM).
9- It is necessary to connect all suction hoods to the suction system.
Before starting the working make sure that the suction system is switched on.
10- Test working to check the cutterblock adjustment may not carried out without the guards required.
11- Never try to remove the wastes or other parts of the workpiece from the working area when the machine is in
operation.
12- Push the workpiece forwards by using a proper pusher or feeder.
13- After a given working period the transmission belts get slack; this may cause an increase of the time
required to stop the tool. In that case immediately stretch the belts (see paragraph 20.23 or 20.24).
14- Periodically remove chips and dust to avoid fire risk: carry out this operation always with the machine off.
DANGER-WARNING:
in case of long machining pauses or machine stops remove the power supply cable socket.
FORBIDDEN:
it is forbidden to use the machine, to perform operations that do not require the use of the toupie
shaft, without having first lowered the toupie shaft completely below the worktop.
DANGER-WARNING:
with interchangeable toupie shaft
, in order to lower the toupie shaft itself completely below
the worktop, it is NECESSARY to remove the spacer rings and the screw that blocks them (see Par.
4.3.76.1).
To Next Page
Loading...
