SCM CU 300C - Profiling Operations; Milling at the Spindle (Shaping); Tenoning

5 - CONTROLS
EN
Pag. 6/14 - Cap. 5 THIS MANUAL IS PROPERTY OF SCM INDUSTRIA S.P.A - ANY TOTAL OR PARTIAL REPRODUCTION IS STRICTLY FORBIDDEN
5.4.1 PROFILING OPERATIONS
(cu_5-4-1_0.0)
Make sure that:
- hood-fence unit (V fig. 5.4-1) is in right position and locked by knobs (H, B fig. 5.4-1).
- NEVER exceed the max speed nMAX indicated on the tool; see Chapter 9A.
- Presser shoes (F and G fig. 5.4-1) cover the toolas much as possible (see paragraph 9.50A); for the
workpiece feed use a proper pusher (S fig. 5.4-1) or a feeder.
5.4.2 MILLING AT THE SPINDLE (SHAPING)
(cu_5-4-2_0.0)
Check that:
- guard (P fig. 5.4-1) is in the right position (with the pin inserted in the slot on the table) and locked by the pin
(M fig. 5.4-1).
- The speed is proper for the tool (see Chapter 9A).
5.4.3 TENONING
(cu_5-4-3_0.0)
Check that:
- tenoning hood (T fig. 5.4-1) is in right position and locked by knobs (R fig. 5.4-1).
- The max. spindle speed is 3500 (4200 - 60 Hz) rpm and that it does not exceed the max. speed permitted for
the fitted tool.