SCM CU 300C - Notes for the user; Spare parts that affect the operators health and safety

EN
1 - GENERAL INFORMATION
THIS MANUAL IS PROPERTY OF SCM INDUSTRIA S.P.A - ANY TOTAL OR PARTIAL REPRODUCTION IS STRICTLY FORBIDDEN Cap. 1 Pag. 7/24
1.4 NOTES FOR THE USER
(gg_1-4_0.0_ce)
The handbook describes all operations required for the normal maintenance of the machine.
Do not carry out any operation not described in this handbook.
All operations which require to desmount machine members as well as maintenance operations shall be carried
out only by authorized technicians.
For the correct use of the machine carry out the proper instructions given in this handbook.
Only trained and authorized technicians may use the machine and carry out maintenance operations.
Keep the general safety norms as well as the rules of industrial medicine.
Keep this handbook for future necessity.
NOTE-INFORMATION:
- use only SCM parts. The manufacturer is not responsible for damages due to the use of not
original parts.
1.4.1 ABBREVIATIONS USED IN THIS HANDBOOK
(gg-1-41_0.0_ce)
pag. = page
fig. = figure
par. = paragraph
chap. = chapter
i.e. = example
ref. = reference
DPI = Individual protective equipment (IPE)
1.4.2 ENCLOSED DOCUMENTATION
(mmax_1-4-2_0.0)
The following attachments are an integral part of this instruction manual:
- Electrical diagrams (read the number of the electrical diagram on the identification plate placed on the
machine in the "W.D." line).
- Spare parts catalogue
NOTE-INFORMATION:
the electrical diagrams are for the exclusive use of competent technicians, therefore they are only
in Italian and English.