EN
3 - TECHNICAL SPECIFICATIONS
THIS MANUAL IS PROPERTY OF SCM INDUSTRIA S.P.A - ANY TOTAL OR PARTIAL REPRODUCTION IS STRICTLY FORBIDDEN Cap. 3 Pag. 11/22
MOULDER
Cast iron table extensions
Manual mouvement of the spindle
Direct start of main motor
Adjustable molder-fence unit
*) Guard of presser unit for moulding
Set of spacer rings on spindle
Tool fixing device
*) Accessories supplied with machine to be mounted according to the type of machining to be carried out.
SURFACE PLANING AND THICKNESSING MACHINE
1.st top feed roller (inlet side): steel scored roller
One feed roller (exit side): steel roller
Height adjusting of thicknessing table by handwheel
Knife setting gauge
N° 3 knives
Suction hood of 120 mm diameter
Direct start of main motor
Planer spindle guards
Tilting guide for supporting pieces
Manual movement of table (planer) in infeed
Reading of removal (planer) with index on sliding scale
To Next Page
Loading...
