SCM CU 300C - Page 287

EN
20 - MAINTENANCE
THIS MANUAL IS PROPERTY OF SCM INDUSTRIA S.P.A - ANY TOTAL OR PARTIAL REPRODUCTION IS STRICTLY FORBIDDEN Cap. 20 Pag. 9/44
DESCRIPTION INSPECTION INTERVALS OPERATIONS
Sliding rods (G fig.
20.1B) of presser unit.
Visual inspection Daily
- With aspirator remove chips
and dust (Par. 20.1).
- With a cloth or a brush drunken
with proper and not dangerous
product.
Worm (V fig. 20.1B) for
spindle height adjusting
Visual inspection Weekly
- Lubricate with grease (Par.
20.3).
Saw driving
Tensioning and wear
check
Weekly
- Tension properly or replace
whenever necessary (Par. 20.23
- 20.18).
Safety and emergency
devices (Chap. 2)
Visual check and
operation test
Every 2 weeks
- Carry out some stopping tests
(Par. 20.7).
SURFACE PLANING AND THICKNESSING MACHINE
DESCRIPTION INSPECTION INTERVALS OPERATIONS
General machine cleaning Visual inspection Daily
- By using an aspirator
remove dust or chips (Par.
20.1).
Tools (B fig. 20.2) of the
planer unit
Visual inspection Daily
- By using an aspirator
remove dust or chips (Par.
20.1).
- Clean with a cloth or
brush soaked in a suitable
product which is not
dangerous.
Sliding rod (D fig. 20.2) of
planer guide
Visual inspection Weekly
- By using an aspirator
remove dust or chips (Par.
20.1).
- Clean with a cloth or
brush soaked in a suitable
product which is not
dangerous.
- Lubricate with oil (Par.
20.3).
Cleaning of suction hoods
(C fig. 20.2)
Visual inspection Weekly
- Disconnect the flexible
tubes from suction hoods,
check that there are no
occlusions and clean by
sucking.
Guides (E fig. 20.2) for
sliding mortiser
Visual inspection Weekly
- By using an aspirator
remove dust or chips (Par.
20.1).
- Clean with a cloth or
brush soaked in a suitable
product which is not
dangerous.
- Lubricate with oil (Par.
20.3).