SCM CU 300C - Page 288

20 - MAINTENANCE
EN
Pag. 10/44 - Cap. 20 THIS MANUAL IS PROPERTY OF SCM INDUSTRIA S.P.A - ANY TOTAL OR PARTIAL REPRODUCTION IS STRICTLY FORBIDDEN
DESCRIPTION INSPECTION INTERVALS OPERATIONS
Sliding rods (P fig. 20.2)
of mortiser table
Visual inspection Weekly
- By using an aspirator
remove dust or chips (Par.
20.1).
- Clean with a cloth or
brush soaked in a suitable
product which is not
dangerous.
- Lubricate with oil (Par.
20.3).
Screw (V fig. 20.2) for
motiser height adjusting
Visual inspection Weekly
- By using an aspirator
remove dust or chips (Par.
20.1).
- Clean with a cloth or
brush soaked in a suitable
product which is not
dangerous.
- Lubricate with grease
(Par. 20.3).
Thicknessing table (H fig.
20.2)
Visual inspection Daily
- Clean with a vacuum
cleaner.
Cleaning the moving
parts, particularly the ones
exposed to the resin and
to the dust
Visual inspection Weekly
- Clean with proper
detergents.
Table lifting chain Visual inspection Weekly
- Clean and lubricate (Par.
20.3).
Thicknessing table -
Screw (S fig. 20.2) for
height adjusting
Visual inspection Weekly
- By using an aspirator
remove dust or chips (Par.
20.1).
- Clean with a cloth or
brush soaked in a suitable
product which is not
dangerous.
- Lubricate with grease
(Par. 20.3).
Thicknessing table -
Sliding cylinder (Z fig.
20.2)
Visual inspection Daily
- By using an aspirator
remove dust or chips (Par.
20.1).
Feed rollers Visual inspection Daily
- Clean with proper
detergents.
Anti
kickback
fingers (L
fig. 20.2)
Visual inspection Daily
- By using an aspirator
remove dust or chips (Par.
20.1). Clean with proper
detergents.
- Do not oil, do not
grease.