SCM CU 300C - Page 289

EN
20 - MAINTENANCE
THIS MANUAL IS PROPERTY OF SCM INDUSTRIA S.P.A - ANY TOTAL OR PARTIAL REPRODUCTION IS STRICTLY FORBIDDEN Cap. 20 Pag. 11/44
DESCRIPTION INSPECTION INTERVALS OPERATIONS
Visual inspection After 1 working hour
- Check that the anti-
kick back fingers are
efficient.
Operator units’ belts (O
fig. 20.2)
Check tensioning and
wear
Daily
- Tension correctly (Par.
20.28) or replace (Par.
20.18) if necessary.
Safety and emergency
devices (Chapter 2)
Visual check and check
functioning
Every 2 weeks
- Perform stop tests (Par.
20.4).