SCM CU 300C - Operations and Adjustments of Spindle

EN
9a - OPERATIONS AND ADJUSTMENTS OF SPINDLE
THIS MANUAL IS PROPERTY OF SCM INDUSTRIA S.P.A - ANY TOTAL OR PARTIAL REPRODUCTION IS STRICTLY FORBIDDEN Cap. 9a Pag. 1/45
INDEX
9A.1 Adjustments ...............................................................................................4
9A.1.1 Spindle height adjusting .............................................................................4
9A.1.1.1 Spindle height adjusting .............................................................................4
9A.3 Spindle speed selection .............................................................................6
9A.3.1 Speed change ............................................................................................7
9A.3.1.1 Speed change ............................................................................................8
9A.6 Telescopic rule on tenoning table ............................................................10
9A.6.1 Rule rotation.............................................................................................10
9A.6.2 To move the rule up to the tool.................................................................10
9A.8 Using the tenoning table ..........................................................................12
9A.8.1 Tenoning ..................................................................................................14
9A.8.1.1 Clamping arm use ....................................................................................14
9A.8.2 Oblique tenons .........................................................................................16
9A.8.2.1 Clamping arm use ....................................................................................16
9A.33 Adjustable Hood-Fence unit.....................................................................18
9A.33.1 Adjust spindle moulder hood guide for moulding without removal ...........21
9A.33.2 Adjust spindle moulder hood for moulding with removal..........................22
9A.33.3 Use of hood-fence for small pieces..........................................................24
9A.33.4 Hood-fence adjusting for profiling with rotation direction reversal............25
9A.33.5 Working examples....................................................................................28
9A.38.4 Hood-fence unit adjusting for working at the front end............................32
9A.44 Tenoning hood .........................................................................................34