SCM CU 300C - Supporting Frame and Fence for Parallel Cuts: Use and Adjustment

To Next Page

To Previous Page

7 - SUPPORTING FRAME AND FENCE FOR PARALLEL CUTS: USE AND

ADJUSTMENT

THIS MANUAL IS PROPERTY OF SCM INDUSTRIA S.P.A - ANY TOTAL OR PARTIAL REPRODUCTION IS STRICTLY FORBIDDEN Cap. 7 Pag. 1/26

INDEX

7.1.3 Splinter guard adjustment ..........................................................................2

7.4 Use of telescopic ruler................................................................................3

7.14 Manual fence for parallel cuts ....................................................................4

7.14.1 Setting to zero the fence for parallel cuts...................................................4

7.14.2 Operation ...................................................................................................6

7.23 Use of sliding table and frame for large panels........................................12

7.23.1 Aluminium sliding table ............................................................................12

7.23.6 Use of the presser unit .............................................................................14

7.24 Example: longitudinal cut .........................................................................16

7.24.1 First cut ....................................................................................................16

7.24.2 Second cut (squaring) ..............................................................................18

7.24.3 Third cut ...................................................................................................18

7.24.4 Fourth cut .................................................................................................19

7.24.5 Cut for obtaining pieces with opposite sides parallel ...............................21

7.24.6 Rule adjusting for oblique cuts ................................................................24

7.24.6.1 Example for positioning the rule for oblique cuts .....................................25

7.25 Additional rule for oblique cuts with millimeter rule ..................................26

Related product manuals