7 - SUPPORTING FRAME AND FENCE FOR PARALLEL CUTS: USE AND
ADJUSTMENT
EN
Pag. 10/26 - Cap. 7 THIS MANUAL IS PROPERTY OF SCM INDUSTRIA S.P.A - ANY TOTAL OR PARTIAL REPRODUCTION IS STRICTLY FORBIDDEN
DANGER-WARNING:
when for the execution of a peculiar working, the operator is obliged to put his hands near the
tools, for safety reasons a proper pusher shall be used to move the workpiece forwards, to push it
against the fence or to remove it after the cutting (see Chap.15).
USING THE PUSHERS
DANGER-WARNING:
before starting to work, ensure that the guard (D fig. 7.14-2A) is resting against the workpiece and,
at the end of the operations, lower it until it comes into contact with the table.
To avoid getting too close to the blades with your hands, use the pusher (H fig. 7.14-2A) supplied
with the machine.
After using this device return to its seating.
When you have to cut small workpieces and you have to push against the fence, you must use the
pushers supplied with the machine.
The handle (A fig. 7.14-2A) is supplied as part of the equipment; it can be applied to pushers of
various dimensions (see Section15).
Fig. 7.14-2A
To Next Page
Loading...
