SCM CU 300C - Thicknessing Use and Adjusting

EN
9 - THICKNESSING USE AND ADJUSTING
THIS MANUAL IS PROPERTY OF SCM INDUSTRIA S.P.A - ANY TOTAL OR PARTIAL REPRODUCTION IS STRICTLY FORBIDDEN Cap. 9 Pag. 1/12
INDEX
9.1 Preliminary adjustment for passing from planing to thicknessing...............2
9.1.1 Machine with manual table lifting ...............................................................2
9.2 Adjustment to pass from thicknessing to surface planing ..........................4
9.2.1 Machine with manual table lifting ...............................................................4
9.4 Automatic feed and speed change.............................................................6
9.5 Manual adjusting of thicknessing table ......................................................7
9.5.1 Adjusting standard indicator.......................................................................8
9.8 Pressure rollers adjusting...........................................................................9
9.9 Safety guards ...........................................................................................10
9.10 Knife adjustment ......................................................................................12
9.11 Knife replacing .........................................................................................12
9.12A Helicoidal planer - Tips replacement........................................................12
9.12 Replacing the throw-away knives.............................................................12