SCM CU 300C - Planer Spindle Guard and Safe Working

EN
10 - USE AND ADJUSTMENT OF PLANER SPINDLE GUARD AND SAFE WORKING
THIS MANUAL IS PROPERTY OF SCM INDUSTRIA S.P.A - ANY TOTAL OR PARTIAL REPRODUCTION IS STRICTLY FORBIDDEN Cap. 10 Pag. 1/20
INDEX
10.1 Cutterblock guard.......................................................................................2
10.1.1 Description .................................................................................................2
10.1.2 Guard adjusting..........................................................................................2
10.3 Procedures for safe working ......................................................................4
10.3.1 Examples....................................................................................................4
10.3.1.1 Surfacing workpieces of thickness less 75 mm..........................................6
10.3.1.2 Straightening ..............................................................................................8
10.3.1.3 Surfacing and straightening pieces thicker than 75 mm ..........................10
10.3.1.4 Surfacing pieces of square section ..........................................................12
10.3.1.5 Surfacing short pieces..............................................................................13
10.3.1.6 Straightening short pieces........................................................................14
10.3.1.7 Chamfering along the fence .....................................................................15
10.3.1.8 Surfacing workpieces with small section..................................................16
10.3.1.9 Straightening workpieces of small section ...............................................17
10.3.1.10 Machining of narrow work-pieces .....................................................18
10.5 Safety notes .............................................................................................20