SCM CU 300C - Page 284

20 - MAINTENANCE
EN
Pag. 6/44 - Cap. 20 THIS MANUAL IS PROPERTY OF SCM INDUSTRIA S.P.A - ANY TOTAL OR PARTIAL REPRODUCTION IS STRICTLY FORBIDDEN
Rules for a correct machine cleaning
SURFACE PLANING AND THICKNESSING MACHINE
Every evening by using a proper aspirator clean:
- the table, cutterblock, anti kickback fingers and the cavities where you see dust and chips seepage;
- periodically clean the rollers by using not dangerous products; never use acid products;
- suction hoods (C fig.20.1) by checking that there are no occlusions.
Never use acid products.
After sucking chips or dust, with a cloth drunken with a not dangerous solvent clean:
- all moving parts, particularly the ones exposed to the resin and to the dust;
- knives (B fig. 20.1C) of the cutterblock;
- sliding rod (D fig. 20.1C) of planer guide
;
- guides (E fig. 20.1C) for mortiser sliding
;
- sliding rods (P fig. 20.1C) of mortising table
;
- screw (V fig. 20.1C) for
mortiser height adjusting;
- thicknessing table - Screw (S fig. 20.2) for height adjusting;
- thicknessing table - Sliding cylinder (Z fig. 20.1C).
FORBIDDEN:
NEVER OIL OR GREASE THE ANTI-KICK BACK FINGERS.