service.fm
A31003-H3590-S100-7-7620, 06/2012
HiPath 3000/5000 V9, Service documentation
12-83
Nur für den internen Gebrauch Service
Guided Maintenance
26-007 !Reload after
load-LW-Code er-
ror
The specified
board has been re-
loaded due to a
startup error.
If this error persists, re-
place the board.
The board is re-
loaded due to a
load error
(length, check-
sum error) or a
missing or de-
layed acknowl-
edgement dur-
ing startup.
Error Class 28 – Recovery Messages
28-000 !not possible to
send a message
Error while trans-
mitting message
via COSMOS (in-
sufficient resourc-
es).
Set up a trace using infor-
mation from BLS.
Create a stack dump.
Save a snapshot.
28-004 !SLC-Trace fin-
ished
SLC LW trace
transferred to trace
memory.
Trace memory can now be
read out.
28-006 --- tttttttt ->
hh:mm:ss ---
DD.MM.YY ---
Time stamp set in
event log B memo-
ry.
None A time stamp
(current time
and date) is en-
tered when the
event log B
memory is cop-
ied. This facili-
tates analysis.
28-008 --- APS:
Hexxxxx.xx.xxx:x
x xxx ----
Current APS ver-
sion entered in
event log B memo-
ry.
None The current APS
version is en-
tered when the
event log B
memory is cop-
ied. This facili-
tates analysis.
Table 12-7 HiPath 3000 Class B Error Messages
No. HiPath 3000/
5000 Manager E:
Event Log Entry
Meaning Required Measures Note
To Next Page
Loading...
