Siemens HiPath 3000 Series - Page 1221

fcodes.fm
A31003-H3590-S100-7-7620, 06/2012
HiPath 3000/5000 V9, Service documentation
B-17
Codes for Activating/Deactivating Features
Disconnect
key
– – – – V – – Local
active
menu,
key
ALL – –
Enable door
opener via
DTMF
*89+Stn.
no.+Code
7589 *89... – U, V,
T
– H – AN, DIG, ENT,
S0, CMI, IPSC
X –
Disable door
opener, DTMF
#89+Stn.
no.+Code
7689 #89... – U, V,
T
– H – AN, DIG, ENT,
S0, CMI, IPSC
X –
Door opener
via adapter
cabinet
*61+Stn. no. 7561 *61... – U, V GS H – AN, DIG, ENT,
S0, CMI, IPSC
– – Only if entrance
telephone is config-
ured
Transfer
(screened/un-
screened)
– ECT
(local S
0
WpC
function-
ality)
– – – RG,
GS
– Drag&
Drop,
Menu
Key
AN, DIG, ENT,
S0, CMI, IP-
SC, IPSI
– – IPSI only support
Transfer after mes-
saging.
Call pickup, di-
rected
*59+Stn. no. 7559... *59... – U – H Using
status-
sup-
ported
speed
dialing
keys
AN, DIG, ENT,
S0, CMI, IPSC
– WA,
RG,
RK,
BS
Call pickup in
pickup group
*57 7557 *57 – V RH,
BR,
GS
U – AN, DIG, ENT,
S0, CMI, IPSC
– WA,
RG,
RK,
BS
Apply DTMF: Flash
TDM WpC with-
out display:
Consultation
hold key
– – – – GS – AN, DIG, ENT,
S0, CMI, IPSC
– –
Table B-1 Codes for Activating/Deactivating Features
Feature
Operating procedure for
Supported
workpoint cli-
ents
(see abbrevi-
ations in
Table B-2)
Locking of
feature
Note
TDM work-
point clients
without dis-
play,
CMI mobile
phones,
analog work-
point clients
1
S
0
work-
point cli-
ents
TDM workpoint clients with
display,
CMI feature mobile phones,
IP workpoint clients
OpenScape
Personal Edition
Code +
Procedure
Code Code
Key Menu
Code
via
Telephone lock
Status
locking on
Fixed
Programm-
able
Dialog
Service
Abbreviations:
● Call states: RH = idle, BR = ready, WA = digit input, BS = busy, RK = incoming call, RG = outgoing call, GS = call
● Key programming: V = key can be programmed with complete feature, U = key can be programmed to start procedure, T = key with
toggle functionality
● Menu level: H = Main menu, U1 = 1st submenu, U2 = 2nd submenu