Sirona Intego - Page 238

64 57 498 D3543
238 D3543.201.01.05.02 08.2016
5Care, cleaning and maintenance by the practice team Sirona Dental Systems GmbH
5.4Vacuum system Operating Instructions INTEGO
Refilling the cleaning agent
When the adjacent display appears on the EasyPad or in the status
column of the touchscreen, the cleaning agent for cleaning the suction
system is almost all gone. It should then be refilled as soon as possible.
Vacuum system, Mixing with DENTOSEPT P
1. Open the maintenance flap on the base of the water unit. The
cleaning agent tank for chemical suction hose cleaning is located on
the left side.
2. Pull the tank slightly out of the water unit. At the same time, check the
hose line.
3. Open the lock of the tank and add the cleaning agent. The cleaning
agent tank has a capacity of 1 liter.
4. Close and slide the tank back into the water unit after filling. The filling
opening must face the front.
With the option chemical suction hose cleaning, the drain outlets of the
cuspidor are not cleaned/disinfected. If the treatment unit is equipped with
this option, the drains of the cuspidor must therefore be cleaned weekly,
see "Cleaning the drain outlets of the cuspidor" [ → 250].
Adjusting the cleaning agent mixture for chemical suction hose
cleaning
In the Setup of the treatment center, it is possible to set the amount of
cleaning agent to be mixed with water, see "Adjusting the cleaning agent
mixture for chemical suction hose cleaning" for the EasyPad [ → 195], for
the EasyTouch [ → 201].
!
Aqua
Amalg
San
1d
41d
B
10:45:03
chem
CAUTION
The cleaning agent for the vacuum system could be mistaken for the
disinfectant for the water lines.
➢ Do not fill DENTOSEPT P disinfectant into the cleaning agent tank
for chemical suction hose cleaning! Use only "Agents for the suction
lines" approved by Sirona, see Care, cleaning and disinfecting
agents" [ → 205].
1LCleanser