Caution: Spectracom Tech Support does not support the editing of the NTP con
figuration files while in the Expert Mode. For additional information on editing
the NTP.conf file, please refer to http://www.ntp.org/.
Note: IMPORTANT: If an undesirable change is made to the NTP.conf file that
affects the NTP operation, the NTP.conf file can be manually changed back as
long as the previous configuration was known.
The NTP.conf file can be reset back to the factory default values by either using the
procedure to restore all of the NetClock factory default settings (see "Restoring the
Default NTP Configuration" on page100) or editing the file back to the original con
figuration as shown in the factory default configuration below.
Caution: If changes are made to the NTP.conf file while in the Expert mode,
Expert mode should remain enabled from that point forward. Disabling Expert
mode after changes being made to this file may result in loss of this configuration
information.
134
CHAPTER 2 • NetClock User Reference Guide Rev. 16
2.15 Configuring NTP
To Next Page
Loading...
