Spectracom NetClock 9489 - Resetting the Unit to Factory Configuration; Resetting All Configurations to Their Factory Defaults

4.
In the Apply License File window, click Upload New File.
5.
In the Upload File window, click Choose File. Using the Explorer window, navigate to
the location mentioned under the first step, select the license file, and monitor the install
ation progress in the Status Upgrade window until the application has rebooted.
6.
Refresh the browser window, and login to the Web UIagain. Re-navigate to Tools >
Upgrade/Backup, and confirm that the newly installed Option is listed in the System
Configuration panel.
4.7 Resetting the Unit to Factory Configuration
In certain situations, it may be desired to reset all NetClock configurations back to the factory
default configuration. The GNSS location, any NetClock configurations and the locally stored
log files can be cleared via the Web UI.
Caution: It is not possible to clear the Authentication logs and NTP logs.
Note: Restoring configurations (reloading a saved configuration), erasing the
stored GNSS location and clearing the log files are separate processes. You may
restore one without restoring the others.
If NetClock was assigned a static IP address before cleaning the configurations, it will be reset
to DHCP after the clean has been performed. If no DHCP server is available after the clean
operation, the static IP address will need to be manually reconfigured. See "Assigning a Static
IP Address" on page44.
4.7.1 Resetting All Configurations to their Factory Defaults
To restore the configuration files to their factory defaults:
1.
Navigate to TOOLS > SYSTEM: Upgrade/Backup.
2.
In the Actions panel, click the Restore Factory Defaults (Clean) button.
4.7 Resetting the Unit to Factory Configuration
CHAPTER 4 • NetClock User Reference Guide Rev. 16
313