Spectracom NetClock 9489 - Restoring the Factory Defaults; Restoring the System Configuration

4.
Click the Upload button. NetClock saves the uploaded bundled file in the
/home/spectracom/xfer/config/directory.
Note: When uploading files remotely via long distances, or when upload
ing multiple files via several browser windows simultaneously, the upload
process may fail to complete. In this case, cancel the upload by clicking X,
and go back to Step2.
5.
To use the new configuration file for this NetClock, click the Restore Configuration but
ton, and follow the procedure described under "Restoring the System Configuration"
below.
4.7.2.4 Restoring the System Configuration
To restore the System Configuration:
1.
Navigate to TOOLS > SYSTEM: Upgrade/Backup.
2.
In the Actions panel, click Restore Configuration.
3.
Click OK in the grey confirmation window. The system will restore the configuration
using the bundled file stored at
/home/spectracom/xfer/config/NetClock.conf, then reboot in order to
read the new configuration file. Once powered back up, NetClock will be configured
with the previously stored file.
4.7.2.5 Restoring the Factory Defaults
For instructions on how to restore the NetClock's configuration files to their factory default set
tings see "Resetting All Configurations to their Factory Defaults" on page313.
318
CHAPTER 4 • NetClock User Reference Guide Rev. 16
4.7 Resetting the Unit to Factory Configuration