Note: Whether or not notifications are enabled/disabled for a given event, the
occurrence of the event is always logged.
All available NetClock events that can generate a notification to be sent are located under dif
ferent tabs in the Notification Events panel: Timing, GPS, and System.
The NetClock Events that can automatically trigger a notification are listed in the Event column.
It is possible to:
Mask the alarm generation for specific events (prevent the alarm)
Enable “SNMP” (to send out an SNMP trap)
Send an email to the address specified in the corresponding “Email Address” column.
4.2.1 Configuring Notifications
To configure Notifications:
1.
Navigate to MANAGEMENT > OTHER: Notifications. The Notifications screen will dis
play:
It is divided into two panels:
The Actions panel, featuring:
The SNMP Setup button: See "SNMP" on page84.
The Email Setup button: Configure NetClock's interface settings for
Exchange email servers and Gmail.
For more information on this subject, see the Spectracom Technical Note
Email Notification Setup.
228
CHAPTER 4 • NetClock User Reference Guide Rev. 16
4.2 Notifications
To Next Page
Loading...
