Spectracom NetClock 9489 - List of Tables

5.9 List of Tables
Table 1-1: Front panel status indications
9
Table 1-2: Status indicators, rear panel
10
Table 1-3: 1PPS output accuracies
22
Table 1-4: 10 MHz output — oscillator types and accuracies
22
Table 1-5: 10 MHz output — oscillator stability
23
Table 2-1: Safety symbols used in this document, or on the product
31
Table 2-2: Subnet mask values
53
Table 2-3: Required Network information
56
Table 2-4: Subnet mask values
56
Table 2-5: Default IP addresses
61
Table 2-6: System Time Message format
94
Table 2-7: System Time Message field descriptions
95
Table 2-8: Signature control output-presence states
142
Table 3-1: Reference priority titles
162
Table 3-2: Receiver dynamics, ~modes, ~ dynamics, ~ types
193
Table 3-3: Estimated Holdover time drifts
212
Table 3-4: Typical Holdover lengths in seconds
212
Table 3-5: TFOM to ETE conversion
217
Table 4-1: Factory default facility and priority codes
305
Table 4-2: Default and recommended configurations
319
Table 5-1: Troubleshooting NetClock, using the front panel Status LED indications
325
Table 5-2: Troubleshooting network connection issues
328
Table 5-3: Troubleshooting using the Web UI Status indications
330
Table 5-4: Troubleshooting 1PPS and/or 10 MHz outputs not being present
332
Table 5-5: Option Modules available for NetClock 9483
336
Table 5-6: ASCII RS-485 pin assignment
341
Table 5-7: NENA module specifications
349
Table 5-8: ASCII RS-232 Output connector pin assignments
351
Table 5-9: Relay/RS-485 outputs pin assignments
352
Table 5-10: Option 13 pin assignments
363
Table 5-11: Clock class definitions
373
Table 5-12: Quality indicators
395
Table 5-13: Available IRIG output signals
414
Table 5-14: IRIG B control function field
420
Table 5-15: FAA Time Error Indicators
423
Table 5-16: IRIG E control function field
427
Table 5-17: Spectracom contact information
430
442 NetClock User Reference Guide
APPENDIX