If you do not have access to NetClock through another admin account, the
spadmin
password
must be reset via the front panel keypad or using the front panel serial port.
Resetting the "spadmin" account password via the keypad:
1.
Use the front panel LCD and the keypad to perform a RESETPW. See also "Front Panel
Keypad, and Display" on page6. (RESETPW is located in the Home/System menus).
2. You will be prompted to confirm the operation before the password is reset. The
spad
min
account password is now reset to “admin123”.
To reset the "spadmin" account password via the serial port, or SSH:
1.
Connect a PC to the front panel serial port, and log in using an account with admin
group rights (such as the
spadmin
account).
2.
Type: resetpw <Enter>. The
spadmin
account password is now reset.
After resetting the password follow the procedure above to change the
spadmin
password in
the MANAGEMENT > OTHER: Authentication window.
4.3 Managing Users and Security
CHAPTER 4 • NetClock User Reference Guide Rev. 16
243
To Next Page
Loading...
