Studer Vista 1 - Page 129

Vista 1 Digital Mixing System
Parameters 3-17
Document generated: 18.04.17
SW V5.3
Standard Dynamics Section (left):
LIM THRS Rotary The limiter threshold can be adjusted in 1 dB steps from 0 dB
FS
to
–48 dB
FS
. The limiter threshold corresponds to the output level.
LIM On/Off Individual limiter on/off control.
LIM ATCK Rotary The limiter attack time can be adjusted in 9 steps within a 200 µs to 1 ms
range.
CMP THRS Rotary The compressor threshold level can be adjusted in 1 dB steps from 0 dB
FS
to
–96 dB
FS
.
CMP On/Off Individual compressor on/off control.
CMP RTIO Rotary The compressor ratio can be adjusted from 1:1 (no com pression) to 20:1
(heavy compression).
Vintage Dynamics Section (right):
CMP THRS Rotary The compressor threshold level can be adjusted in 1 dB steps from 0 dB
FS
to
–96 dB
FS
.
CMP RTIO Rotary The compressor ratio can be adjusted from 1:1 (no com pression) to 40:1 (extra
heavy compression).
CMP peak/RMS Level detection mode: peak or RMS
CMP ATCK The compressor attack time can be adjusted in 64 steps within a range of
0.2 ms to 250 ms.
MKUP GAIN auto on/off ‘auto on’ automatically compensates a level loss caused by the dynamics
processing. ‘auto off’ activates the manual MKUP GAIN rotary control.
MKUP GAIN Rotary To manually compensate a level loss caused by the dynamics processing,
adjustable in 1 dB steps from 0 through +24 dB.