Studer Vista 1 - Panning Parameters for 5.1 Surround Channels

Vista 1 Digital Mixing System
3-46 Parameters
Document generated: 18.04.17
SW V5.3
3.4.4.5 Panning Parameters for 5.1 Surround Channels
Touch the yellow Vistonics pan field.
General PAN On/Off is selected with the PAN hardware key above the Vistonics section.
CENT LEVEL Center level control from MUTE (i.e. –∞ dB) to +10 dB.
FB On/Off On/off switch for center channel contribution to the F-R control.
FRONT L-R Frontpanningbetweentheleft,(center)andrightchannelsin1°steps.The
contribution to the center channel is determined by the CENTER control.
F-R This parameter allows variable blending from front to rear channels in 60
increments, either with a contribution from the center channel (FB On) or
without (FB Off).
REAR L-R Panningbetweentheleftandrightsurroundchannelsin1°steps.
PANARND On/Off Activates the Pan-Around function.
PANARND Single-knobfunction,allowsrotatingthesurroundsoundfieldby±180°.
LFE On/Off On/off selector for LFE channel use.
LFE LEVEL LFE channel percentage control; 0% = no LFE channel use, 100% = LFE
channel fully active.