Vista 1 Digital Mixing System
2-32 Desk Operation
Document generated: 18.04.17
SW V5.3
2.2.5.8 Talkback Control
TALKBACK Whenever TALK is pressed, the signal from the talkback microphone input is
fed to the corresponding group.
The talkback input usually is microphone input no. 32. It is pre-configured
but not activated, refer to chapter 2.1.5.
Note: The talkback signal is inserted directly before the output interface of the
core. If signals are routed internally to some other destinations, the talkback
will not harm them.
Available talk destinations:
AUX Direct outputs of all AUX masters
GRP Direct outputs of all group masters
MAST Direct outputs of all masters
DIR Direct outputs of all input channels
BUS Outputs of all multi-track buses (without faders in between)
STUDIO Talkback to both Studio A and B simultaneously).
AUX 1...4 STEREO For talking to headphone mixes, these keys can be used to directly activate
talkback to the corresponding AUX master outputs.
A talkback and signaling block diagram is shown on the next page.
To Next Page
Loading...
