Studer Vista 1 - Page 131

Vista 1 Digital Mixing System
Parameters 3-19
Document generated: 18.04.17
SW V5.3
GATE hyst on/off The gate hysteresis function provides an offset between the un-mute and mute
thresholds. So the gate will remain open (un-muted) at a level slightly lower
than the one required to open it in order to avoid effects such as chattering.
Vintage Dynamics Section There are two different views for the vintage expander/gate view; one of them
(below left) is displayed when pressing the EXP GATE hardware key, and the
other one (below right) when pressing  (Shift) before the EXP GATE key.
Standard View: ‘Shift’ View:
Standard View
GATE THRS Rotary The gate threshold level can be adjusted in 1 dB steps from 0 dB
FS
to
–96 dB
FS
.
GATE ATTN Rotary The gate attenuation level can be adjusted in 1 dB steps from 0 dB
FS
to
+60 dB
FS
.
GATE ATCK Rotary The gate attack time can be adjusted in 64 steps within a range of 0.2 ms to
5 ms.
GATE HOLD Rotary The gate hold time can be adjusted in 64 steps from 0 ms to 2000 ms.
‘Shift’ View EXP THRS Rotary The expander threshold level can be adjusted in 1 dB steps from 0 dB
FS
to
–96 dB
FS
.
EXP RATIO Rotary The expander ratio level can be adjusted from 1:1 (no expansion) to 1:40
(heavy expansion).
EXP ATCK Rotary The expander attack time can be adjusted in 64 steps within a range of 0.2 ms
to 5 ms.
EXP HOLD Rotary The expander hold time can be adjusted in 64 steps from 0 ms to 2000 ms .