Vista 1 Digital Mixing System
3-36 Parameters
Document generated: 18.04.17
SW V5.3
CMP MIX on/off ‘on’ activates the CMP MIX function; ‘off’ selects the compressed signal
only.
When the CMP MIX function is set to ‘on’, the ratio of the dry (original) to
the wet (compressed) signal depends on the selected mix ratio. In other words,
mixing between the original and the compressed signals is possible.
CMP REL Rotary The compressor release time can be adjusted within a 5 ms to 5 s range.
CMP ATCK Rotary The compressor attack time can be adjusted in steps within a 200 µs through
250 ms range.
CMP RTIO Rotary The compressor ratio can be adjusted from 1:1 (no com pression) through 40:1
(very heavy compression).
EXP / GATE MODE Rotary Used for selecting either the expander or the gate function for the vintage
dynamics section. The threshold, release, attack and hold parameters of
expander and gate are adjusted in common; they cannot be set individually.
EXP / GATE REL Rotary The expander/gate release time can be adjusted within a 5 ms through 5 s
range.
EXP / GATE ATCK Rotary The expander / gate attack time can be adjusted within a 0.5 through 5 ms
range.
EXP RTIO Rotary The expander ratio can be adjusted from 1:1 (no expansion) through 1:40
(very heavy expansion).
EXP / GATE hold Rotary The expander / gate hold time can be adjusted within a 0 through 2 s range.
To Next Page
Loading...
