Vista 1 Digital Mixing System
3-40 Parameters
Document generated: 18.04.17
SW V5.3
INP DIR / BAL Selection from two input functions: INP BAL or INP DIR.
INP DIR / INP BAL Rotary The INP DIR function is used to control the direction of a stereo input signal.
Turningtherotaryencodershiftstheinputdirectionin1°stepsfrom–30°
(left)to+30°(right).
The INP BAL function is used to control the balance of a stereo input signal.
Turning the rotary encoder to the left attenuates the right channel from 0 to
–∞ dB while the left channel remains at full input level, and vice versa.
DIR WIDTH On/Off Optional, only if the width function is configured.
Switches the DIR WIDTH function on/off.
DIR WIDTH Rotary Optional, only if the width function is configured.
The DIR WIDTH parameter is used to control the width of the stereo signal.
It is only functional if there is a difference between the left and right input
channels, or if IBAL or IDIR has been used to create an offset between the
channels. The ST DIR control directs the position of the stereo signal, while
the DIR WIDTH control determines the width or stereo spread either side of
that position. DIR WIDTH operates over a range from 0% (mono) to 200%
(‘super stereo’).
ST DIR Rotary Left/right(orodd/even)panningcontrolforastereooutputsignalin1°steps
from–30°(fullyleft)to+30°(fullyright).
To Next Page
Loading...
