1A-37 Engine General Information and Diagnosis:
C14 (Use of mode select switch)
Step Action Yes No
1 1) Turn the ignition switch OFF.
2) Lift and support the fuel tank. Refer to “Fuel Tank
Removal and Installation in Section 1G (Page 1G-7)”.
3) Check the TP sensor coupler (1) for loose or poor
contacts.
If OK, then measure the TP sensor input voltage.
4) Disconnect the TP sensor coupler.
5) Turn the ignition switch ON.
6) Measure the input voltage between the R wire “A” and
ground.
If OK, then measure the input voltage between the R
wire “A” and B/Br wire “B”.
Special tool
(A): 09900–25008 (Multi-circuit tester set)
Tester knob indication
Voltage ( )
TP sensor input voltage
4.5 – 5.5 V
((+) terminal: R – (–) terminal: Ground, (+) terminal: R
– (–) terminal: B/Br)
Is the voltage OK?
Go to Step 2. Open circuit in the R or
B/Br wire.
1
I944H1110021-01
(A)
V
“A”
“B”
I944H1110119-01
To Next Page
Loading...
