Engine Mechanical: 1D-20
22) Disengage the gearshift link arm (23) by removing
the bolt (24).
NOTE
Mark the gearshift shaft head at which the
gearshift link arm slit is set for correct
reinstallation.
23) Remove the side-stand switch (25) and clamp (26).
24) Remove the engine sprocket outer cover (27).
25) Remove the speed sensor (28).
26) Remove the engine sprocket inner cover (29).
27) Remove the dowel pins (30).
28) Remove the speed sensor rotor (31) by removing its
bolt (32) while depressing the rear brake pedal.
29) Flatten the lock washer (33).
30) Remove the engine sprocket nut (34) while
depressing the rear brake pedal.
31) Remove the lock washer (33).
32) Loosen the rear axle nut (35).
33) Support the motorcycle with a jock or wooden block.
CAUTION
!
Make sure that the motorcycle is supported
securely.
23
24
I944H1140301-02
25
26
I944H1140302-02
27
I944H1140303-02
29
28
I944H1140304-04
31
32
30
I944H1140305-03
33
34
I944H1140306-02
To Next Page
Loading...
