Engine Mechanical: 1D-66
Oil Gallery Plug
• Tighten each plug to the specified torque.
CAUTION
!
Use each new gasket.
Tightening torque
Oil gallery plug (M6) (a): 10 N·m (1.0 kgf-m, 7.0
lbf-ft)
Oil gallery plug (M8) (b): 18 N·m (1.8 kgf-m, 13.0
lbf-ft)
Oil gallery plug (M12) (c): 21 N·m (2.1 kgf-m, 15.0
lbf-ft)
Oil gallery plug (M16) (d): 35 N·m (3.5 kgf-m, 25.5
lbf-ft)
Crankcase Journal Bearing
• Set the specified crankshaft journal bearings (1) to the
special tool.
CAUTION
!
Before setting the bearing, apply
molybdenum oil solution to the special tool
and bearings.
M/O: Molybdenum oil (MOLYBDENUM OIL
SOLUTION)
Special tool
(A): 09913–60221 (Journal bearing installer
and holder)
• When setting the bearing, align the bearing side with
the engraved line “A” and also the bearing end with
the mating surface of the special tool.
NOTE
The upper and lower bearings are same.
(a)
(c)
(b)
(b)
I944H1140048-01
(a)
I944H1140049-01
(b)
(d)
I944H1140050-01
(A)
1
I944H1140051-01
“A”
I944H1140052-01
To Next Page
Loading...
