1D-67 Engine Mechanical:
• Tighten the special tool bolts to the specified torque.
Special tool
(A): 09913–60221 (Journal bearing installer
and holder)
Tightening torque
Special tool bolt (a): 23 N·m (2.3 kgf-m, 16.5 lbf-ft)
• Set the bearings installed in the special tool to the
crankcase half as shown.
CAUTION
!
• Before installing the bearings, lightly
shave off the sharp edge part “B” of the
crankcase chamfer by using an oilstone
and wash the crankcase bore with enough
molybdenum oil solution.
• Be sure the bearing protruded side “C”
faces the crankcase bore.
• Align the bearing/special tool mating
surface with the line “D” on the crankcase.
NOTE
Install the bearing from inside to outside of
each crankcase halves.
M/O: Molybdenum oil (MOLYBDENUM OIL
SOLUTION)
• The color code of the bearing must face crankshaft
side.
• Apply enough molybdenum oil solution to the special
tool and the bearings and then set the special tool
carefully.
Special tool
(A): 09913–60221 (Journal bearing installer
and holder)
M/O: Molybdenum oil (MOLYBDENUM OIL
SOLUTION)
• Gradually press in the bearing into the main journal
bore by using the hydraulic press until the special tool
(1) contacts the special tool (2).
(a)
(a)
(A)
I944H1140053-01
“B”
I944H1140054-01
“C”
“D”
I944H1140055-01
I944H1140056-01
(A)
I944H1140057-01
To Next Page
Loading...
