Suzuki SFV650 - Page 257

Engine Mechanical: 1D-68
• After installing the bearings (1), check the bearing
surface for any scratch or damage.
Oil Jet
• Fit the new O-rings to each oil jets.
CAUTION
!
Use the new O-rings to prevent oil leakage.
• Apply grease to new O-ring.
: Grease 99000–25010 (SUZUKI SUPER
GREASE A or equivalent)
• Install the oil gallery jet (for transmission) (1) with a
suitable bar.
• Tighten the oil gallery plug (M8) (2) and (M6) (3) to the
specified torque.
CAUTION
!
Replace the gaskets with new ones.
Tightening torque
Oil gallery plug (M8) (a): 18 N·m (1.8 kgf-m, 13.0
lbf-ft)
Oil gallery plug (M6) (b): 10 N·m (1.0 kgf-m, 7.0
lbf-ft)
• Install the clutch push rod oil seal (4) with the special
tool.
CAUTION
!
Replace the clutch push rod oil seal with a
new one.
Special tool
(A): 09913–70210 (Bearing installer set)
1. Journal bearing 2. hydraulic press
2
(A)
(A)
1
2
(A)
(A)
1
I944H1140058-02
1
Left side
1
Right side
I944H1140059-03
1
1
I944H1140060-01
(b)
3
(a)
2
I944H1140061-01