Engine Mechanical: 1D-70
• Install the crankshaft assembly into the left crankcase.
CAUTION
!
Never strike the crankshaft with a plastic
hammer when inserting it into the crankcase.
NOTE
• Be sure to set the crankshaft in the proper
direction.
• Of the two conrods, the one with the
embossed letter marked should be
brought to the rear cylinder.
Oil Pressure Regulator
• Tighten the oil pressure regulator (1) to the specified
torque.
Tightening torque
Oil pressure regulator (a): 27 N·m (2.7 kgf-m, 19.5
lbf-ft)
Oil Strainer
• Install the oil strainer (1).
CAUTION
!
• The lip “A” of the oil strainer should be
positioned downward.
• The shorter side “B” of the oil strainer
should be positioned inside.
• Install the oil strainer plate (2).
I944H1140071-01
(a)
1
I944H1140067-01
“A”: Lip “C”: Lower side
“B”: Shorter side
1
“B”
I944H1140068-01
“A”
“C”
“B”
I944H1140069-01
2
I944H1140070-02
To Next Page
Loading...
