Suzuki SFV650 - Page 261

Engine Mechanical: 1D-72
• Apply grease to the oil seal lip and O-ring (4).
CAUTION
!
Use the new O-ring to prevent oil leakage.
: Grease 99000–25010 (SUZUKI SUPER
GREASE A or equivalent)
• Install the engine sprocket spacer (5).
NOTE
The grooved “A” side of the engine sprocket
spacer (5) must face crankcase side.
• Install the oil plate (6).
• Tighten the oil plate bolts (7) to the specified torque.
Tightening torque
Oil plate bolt (c): 10 N·m (1.0 kgf-m, 7.0 lbf-ft)
Gear Position Switch
• Apply grease to the O-ring.
CAUTION
!
Replace the O-ring with a new one.
NOTE
Align the gear position switch pin “A” with
the gearshift cam hole “B”.
: Grease 99000–25010 (SUZUKI SUPER
GREASE A or equivalent)
• Install the gear position switch (1).
• Install the drive shaft oil seal retainer (2).
NOTE
Pass the gear position switch lead wire under
the driveshaft oil seal retainer.
4
I944H1140076-01
5
“A”
“A”
I944H1140077-01
6
(c)
7
I944H1140078-02
“A”
“B”
I944H1140079-01
1
I944H1140080-02
2
I944H1140081-02